routerdefaults.ORG IP addresses, usernames, passwords, and more

Default settings of the Amped Wireless RTA2600-R2

Here you can find the default IP address and the predefined access data for the user interface of the RTA2600-R2 AC2600 MU-MIMO Wi-Fi router of Amped Wireless. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.3.1 (or http://setup.ampedwireless.com)
Username:
<blank>
Password:
<blank>

Preconfigured Wi-Fi settings

SSID:
starts with Amped_Athena_
Password:
wireless

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Amped Wireless RTA2600-R2, you have to do the following steps for access:

  1. Turn on router
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Open browser
  4. Paste IP address or URL in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the login form and confirm
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Amped Wireless RTA2600-R2 to its default settings, you have to do the following steps:

  1. Switch on router
  2. For at least 10 seconds, press the Reset button
  3. Restart of the device is automatically executed
  4. Default settings have been restored

Execute software reset

With the Amped Wireless RTA2600-R2, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.