routerdefaults.ORG IP addresses, usernames, passwords, and more

Default settings of the Belkin F5D8230-4

Here you can find the default IP address and the predefined access data for the user interface of the F5D8230-4 Wireless Pre-N router of Belkin. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.2.1
Username:
<blank>
Password:
<blank>

Preconfigured Wi-Fi settings

SSID:
starts with Belkin Pre-N_
Password:
<blank>

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Belkin F5D8230-4, you have to do the following steps for access:

  1. Switch on router
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Start web browser
  4. Enter IP address in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Belkin F5D8230-4 to its default settings, you have to do the following steps:

  1. Switch on router
  2. Press Reset button for at least 10 seconds
  3. Device is automatically restarted
  4. Router has been reset to factory settings

Execute software reset

With the Belkin F5D8230-4, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.