Default settings of the Belkin F7D1301
Here you can find the default IP address and the predefined access data for the user interface of the F7D1301 N150 Wireless router of Belkin. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.
Login data for the user interface
- IP address:
- 192.168.2.1 (or http://router/)
- Username:
- <blank>
- Password:
- <blank>
Preconfigured Wi-Fi settings
- SSID:
- on an information card that comes with the router
- Password:
- on an information card that comes with the router
Access to the user interface
Accessing the user interface is necessary when you want to change the router configuration. For the Belkin F7D1301, you have to do the following steps for access:
- Switch on router
- Connect the device via Wi-Fi* or a network cable with the router
- Open browser
- Insert IP address or URL into the address bar and confirm with ‘Enter’ button
- Enter password in the open user interface and confirm again
This router can also be configured with the provided software.
* Make sure that your router’s Wi-Fi is activated.Reset default settings
Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.
Execute hardware reset
To reset the Belkin F7D1301 to its default settings, you have to do the following steps:
- Switch on router
- Press Reset button and hold for at least 10 seconds
- Device is automatically restarted
- Default settings have been restored
After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.