routerdefaults.ORG IP addresses, usernames, passwords, and more

Default settings of the Buffalo WXR-1900DHP

Here you can find the default IP address and the username and password for the user interface of the Buffalo WXR-1900DHP AirStation Dual-Band Wireless router. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.11.1
Username:
admin
Password:
password

Preconfigured Wi-Fi settings

SSID:
on an information card that comes with the router
Password:
on an information card that comes with the router

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Buffalo WXR-1900DHP, you have to do the following steps for access:

  1. Put router into operation
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Start web browser
  4. Insert IP address in the address bar and confirm with ‘Enter’ button
  5. Enter username and password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Buffalo WXR-1900DHP to its default settings, you have to do the following steps:

  1. Switch on router
  2. Press RESET button and hold for at least 4 seconds
  3. Device restarts automatically
  4. Router has been reset to factory settings

Execute software reset

With the Buffalo WXR-1900DHP, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.