routerdefaults.ORG IP addresses, usernames, passwords, and more

Default settings of the Linksys WRT3200ACM

Here you can find the default IP address and the predefined access data for the user interface of the WRT3200ACM MU-MIMO Gigabit WiFi AC3200 router of Linksys. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.1 (or http://myrouter.local)
Username:
<blank>
Password:
<blank>

Preconfigured Wi-Fi settings

SSID:
in the documents that come with the router
Password:
in the documents that come with the router

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Linksys WRT3200ACM, you have to do the following steps for access:

  1. Put router into operation
  2. Set up a connection between the device and the router via Wi-Fi* or network cable
  3. Start web browser
  4. Paste IP address or URL in the address bar and then confirm with ‘Enter’ key
  5. Enter password in the open user interface and confirm again
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Linksys WRT3200ACM to its default settings, you have to do the following steps:

  1. Switch on router
  2. For at least 10 seconds, press the Reset button
  3. Restart of the device is automatically executed
  4. Router has been reset to factory settings

Execute software reset

With the Linksys WRT3200ACM, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.