routerdefaults.ORG IP addresses, usernames, passwords, and more

Default settings of the Netgear WNR2020

Here you can find the default IP address and the username and password for the user interface of the Netgear WNR2020 N300 WiFi router. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.

Login data for the user interface

IP address:
192.168.1.1 (or http://www.routerlogin.net)
Username:
admin
Password:
password

Preconfigured Wi-Fi settings

SSID:
on a sticker on the router’s case
Password:
on a sticker on the router’s case

Access to the user interface

Accessing the user interface is necessary when you want to change the router configuration. For the Netgear WNR2020, you have to do the following steps for access:

  1. Put router into operation
  2. Connect the device via Wi-Fi* or a network cable with the router
  3. Open browser
  4. Insert IP address or URL into the address bar and confirm with ‘Enter’ button
  5. Enter username as well as password in the login form and confirm
* Make sure that your router’s Wi-Fi is activated.

Reset default settings

Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.

Execute hardware reset

To reset the Netgear WNR2020 to its default settings, you have to do the following steps:

  1. Switch on router
  2. Press WPS/Reset button and hold for at least 4 seconds
  3. Restart of the device is automatically executed
  4. Router has been reset to factory settings

Execute software reset

With the Netgear WNR2020, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.

After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.